Max Flow

The Max-Flow High Flow filter is suited for applications such as cooling water, Pre-RO, and resin trap filtration.
It is a large diameter, coreless, single open-ended, pleated cartridge with an inside to outside flow . Puts an extraordinary amount of surface area into a single cartridge.

• High dirt loading capacity for long service time and lower cost filtration
• Up to forty conventional depth filters minimize
  initial cost
• Inside to outside flow configuration all
  contaminants held within the single ended filter
• Shorter in down time for element replacement
• Smaller equipment footprint
• Coreless construction minimizes disposal cost

Maximum operating forward pressure drop:
3.5bar (50 psi) at 25°C (77°F)

Maximum operating temperature: 80°C (176°F)

• RO Pre-Filtration
• UF Membrane Pre-Filtration
• Cooling water filtration
• Pre filters or Final filters for waste water

Micron Rating: 1, 5, 10, 25, 50, 75 μm

Material of Construction:
Filter Medium: Pleated Polypropylene depth structure
Support and drainage : Polypropylene
End caps : Polypropylene
Outer Diameter: 152.4mm (6 inches)
Inner Diameter: 80mm (3.2 inches)
Length: 508mm (20 inches), 1016mm (40 inches), 1524mm (60 inches)
O-Ring : EPDM(Standard), Viton, Silicone, PEA encapsulated Viton

Pressure Drop & Retention Rate